Forward Controls Design EMR-H Magazine Catch Button
The EMR-H features a slightly curved button surface to fit the natural curvature of your finger.
The form fitting curve, along with horizontal serrations, create a self centering surface that inhibits the finger’s vertical movements. The EMR-H has a milspec through hole for the magazine catch’s shaft, and is only 0.02″ taller than the factory magazine release button. When installed, the EMR-H has minimal protrusion above the mag release button fence on most forged receivers.
Machined from 4140 bar stock, it is QPQ coated. In late 2019, 7075 aluminum EMR was replaced by 4140 steel EMR-H (heavy). EMR-H joins the MSQ-H (MLOK, Sling Adapter, Heavy) and ESF-H (End plate, Sling adapter, Heavy) in the H (heavy) line of components.
Please visit the EMR vs EMR-C page for an in depth review of the differences between the EMR and EMR-C.
Proudly made in the USA.
holdovermedia (verified owner) –
Highly recommend. Little details like this add up
Arturo Gonzalez (verified owner) –
Much better than stock! Good quality
Kyle (verified owner) –
Anything made by FCD is worth buying.
As always, thank you to the sweat shop for fast shipping!!
Earl Stanley (verified owner) –
Didn’t think a mag release button would be a big deal but ordered one since I was doing a centurion/FCD build. Damn! That dimpled button actually is an improvement over the standard one.
Thanks rooftop for the fast shipping and free meal!
bigbyrd94 (verified owner) –
Solid magazine button. Texture is a huge improvement over the standard milspec.